Time for something different – a single button combination lock. Allow me to explain…
Normally a combination lock would require the entry of a series of unique numbers in order to unlock something or start an action. For example:
A more contemporary type of lock could be controlled electronically, for example by a keypad where the user enters a series of digits to cause something to happen. Such as the keypad on this dodgy $30 safe from Officeworks:
As you can see there is a button for each digit. You would think that this would be a good idea – however people can watch you enter the digits, or users can be silly enough to write down the combination somewhere. In some cases the more cunning monkeys have even placed cameras that can observe keypads to record people entering the combination. There must be a better way. Possibly! However in the meanwhile you can consider my idea instead – just have one button. Only one button – and the combination is made up of the time that elapses between presses of the button. There are many uses for such an odd lock:
- A type of combination lock that controls an electric door strike, or activates a device of some sort;
- A way of testing mind-hand coordination for skill, or the base of a painfully frustrating game;
- Perhaps an interlock on motor vehicle to prevent drink driving. After a few drinks there’s no way you could get the timing right. Then again, after a double espresso or two you might have problems as well.
We measure the duration of time between each press of the button (in this case – delay 1~4). These delay times are then compared against values stored in the program that controls the lock. It is also prudent to allow for some tolerance in the user’s press delay – say plus or minus ten to fifteen percent. We are not concerned with the duration of each button press, however it is certainly feasible.
To create this piece of hardware is quite easy, and once again we will use the Arduino way of doing things. For prototyping and experimenting it is simple enough to create with a typical board such as a Uno or Eleven and a solderless breadboard – however to create a final product you could minimise it by using a bare-bones solution (as described here). Now let’s get started…
For demonstration purposes we have a normally-open button connected to digital pin 2 on our Arduino-compatible board using the 10k ohm pull down resistor as such:
Read more: Single button combination lock using Arduino