In this tutorial we are going to tell you about how we can interface lcd with 8051 in 4-bit mode. Step 1: Software Used: As we are showing proteus simulation so FOR CODING AND SIMULATION YOU REQUIRED: 1 Keil uvision: Their are lots of …
Interfacing 8051 Microcontroller With Lcd in 4-bit Mode Using Atmega Read More »
Arduino-Remote Control Home Automation In this project, we are going to show you how to control home appliances using a TV Remote. This same principle can be applicable in offices and industries as well. The project deals with the automation of four home appliances, like Tube lights, fan, bulbs, and of course TV. To automate them, …
Project: Home Automation Using IR Remote Control Using Arduino Read More »
Send status messages of your MKR1000 via Pushover service to your mobile phone, etc. Things used in this project Hardware components Arduino MKR1000 Story An IoT node must be trimmed to reduce current consumption due to battery life. A WiFi-based node as Arduino MKR1000 needs a lot of current while sending. To avoid a high …
In this DIY guide I will show you how to make your own wireless weather station! My communication protocol will allow you to have up to 10 sensor stations in your wireless network, but you can change and extend it up to 254 stations! The RF …
Arduino Based Wireless (RF) Weather Station Network Read More »
Dear friends welcome to another Instructable! Today we are going to learn how to get the data that this Xiaomi Temperature and Humidity monitor transmits using the Bluetooth functionality of the ESP32 board. As you can see, I am using an ESP32 board and a 2.8” color …
ESP32 Xiaomi Hack – Get Data Wirelessly Using Arduino Read More »
This project describes the second part of the following two projects: A wireless doorbell transmitter as described in the Wireless Doorbell Transmitter Instructable. This Instructable also gives some introduction to these projects. A wireless doorbell receiver described in this Instructable. The wireless doorbell receiver will make a sound and will blink a LED 5 times after it …
This project describes the first part of the following two projects: A wireless doorbell transmitter as described in this Instructable A wireless doorbell receiver to be described in the Wireless Doorbell Receiver Instructable When I am sitting in the backyard of my house I cannot hear it when somebody is ringing the doorbell at the front door. …
This project describes the second part of the following two projects: A wireless doorbell transmitter as described in the Wireless Doorbell Transmitter Instructable. This Instructable also gives some introduction to these projects. A wireless doorbell receiver described in this Instructable. The wireless doorbell receiver will make a sound and will blink a LED 5 times after it …
I am very excited to share this project with you because it looks absolutely beautiful and is super easy to make! It’s a NanoLeaf inspired wireless Arduino RGB LED lights project that not only allows you to create any custom NanoLeaf shape you want but also use the same identical segments to create a 4-digit …
Custom NanoLeaf Lights! DIY, Wireless, Modular, Arduino, 3D Printed! Read More »
The WiFi Shield was delivered by Amazon. The Arduino UNO Rev 3 was found at RadioShack… First you need to load the last Arduino IDE (Ver 1.0.2) it has the necessary library to use the WiFi shield. Tried the examples “Scan for available networks” and “WPA network example” from: http://arduino.cc/en/Guide/ArduinoWiFiShield It works like a charm! …
