The project is basically to detect the theft from the energy meter used in households as well as in…
The project is basically to detect the theft from the energy meter used in households as well as in the commercial sector. There is two based meter one for distribution line and one for the consumer side. Whenever the distribution line load reading does not match the consumer side reading; that means there is some kind of power leakage in between distribution and consumer line, leads to deference in energy readings, and theft will be detected. When the theft will occur, a notification will be sent to the app and consumer side power will be cut off. The data send to the Blynk Application Dashboard and display’s the Voltage, Current, Power & total unit consumed in kWh with theft detection alert.
Project Used Hardware
ESP32, ACS712 current sensor module, ZMPT101B voltage sensor module, Relay module, Connection Wires
Project Used Software
Arduino, Blynk IoT platform
Project Hardware Software Selection
I need to select the current sensor as well as the voltage sensor so that the current & voltage can be measured and thus I can know about the power consumption & total power consumed for theft detection with the help of ESP32 and IoT Blynk platform.
ESP32: ESP32 microcontroller module offers a built-in Wi-Fi feature which is ideal for IoT projects since the project is based on the same.
ZMPT101B: ZMPT101B is a high-precision voltage Transformer I use to measure the accurate AC voltage.
ACS712: ACS712 is a fully integrated, hall effect-based linear current sensor use to measure the alternating current in this project.
Relay Module: The relay module is used as a switch for the mains power line. It is controlled by ESP32, when theft is detected, the relay activates and cuts the mains power.