Popsicle Stick Robotic Arm Using Arduino

Here’s how to build a simple robotic arm with a gripper using popsicle sticks, an Arduino, and a few servos.

Supplies:

Feel free to use similar materials or whatever you already have. (e.g. cardboard instead of popsicle sticks)

Materials:

• 14 Popsicle Sticks
• 4 Micro Servos (with their horns and screws)
• 4 Rotary Potentiometers
• 1 Half Size Breadboard
• 1 Arduino Uno
• 1 6-Volt Battery Pack
• 26 Jumper Cables

Tools:

• Hot Glue Gun + Hot Glue Sticks
• Precision screwdriver or other small screwdriver
• Arduino IDE
• USB to Arduino Cable

Step 1: Choose Horns for Your Servos

 

 

 

 

 

 

 

 

 

 

Materials for This Step:

• 4 Micro Servos
• 3 Horns that extend in 2 directions
• 1 Horn that extends in 1 direction

Instructions:

Attach the horns (white wing attachments) to the servos. Three of the servos need the horn that extends in two directions while one servo will need the horn that extends in just one direction. Simply pop the horns onto the top of the servos.

Step 2: Calibrate the Servo

Materials for This Step:

• 4 Micro Servos

Instructions:

Turn the horn counter-clockwise as far as possible. Then, pop the horn off and back on at the calibrated position.

One of the servos with the double-direction horns needs to be calibrated parallel to the servo while the other three need to be calibrated perpendicular to the servos.

Above is a picture of the calibrated servos turned fully counterclockwise. These are the calibrated positions.

Why calibrate the servos? Servos only move 180 degrees so it’s important that we calibrate the servos so that the servo turns between the angles we want therm to.

Step 3: Screw in the Servos

Materials for This Step:

• 4 Micro Servos
• 4 Small Screws
• Precision screwdriver or other small screwdriver

Instructions:

Screw the horns in using a small screw and the appropriate screwdriver.

Step 4: Attach Popsicle Sticks to Servos (pt 1/4)

 

 

 

 

 

 

 

 

 

 

 

Materials for This Step:

• The one servo that was calibrated so the horn is parallel to the servo
• 1 Popsicle Stick
• Hot Glue Gun

Instructions:

For the servo that was calibrated so the horn is parallel to the servo, hot glue one end of the popsicle stick to the flat side of the horn.

Above is a picture of this servo turned completely counterclockwise.

Step 5: Attach Popsicle Sticks to Servos (pt 2/4)

Materials for This Step:

• One of the other two servos that have double-direction horns
• 1 Popsicle Stick
• Hot Glue Gun

Instructions:

Glue one end of the popsicle stick to the flat side of the servo’s horn.

Above is a picture of this servo turned completely counterclockwise.

Step 6: Attach Popsicle Sticks to Servos (pt 3/4)

Read more: Popsicle Stick Robotic Arm