This post answers the question, “How to make a pulse width modulator using PIC16F877” ?
Also, using PIC16 simulator (Proteus) you can verify this PWM code and change it according to your needs. You can download the complete project code and Proteus simulation from the ‘Downloads‘ section at the bottom of this page.
This PIC16F877 microcontroller tutorial provides the 2 channel PWM code (using C language) and Proteus simulation ( written using MPLAB and HI-TECH C compiler ). There are many uses for PWM signal, e-g you can control dc motor speed using PWM. CCP is the name for the built in PWM module in PIC16F877. There are 2 built in PWM modules available, namely CCP1 and CCP2. This code is using both CCP1 and CCP2 modules to generate 2 separate PWM signals.
It is assumed that you know how to blink an LED with PIC16F877 microcontroller. If you don’t then please read this page first, before proceeding with this article.
The following diagram (made in Proteus) shows the PWM generator circuit diagram.
A crystal of 20MHz is used here with PIC16F877. As we know that any PIC micro controller has an architecture which executes an instruction in 4 CPU cycles, hence this 20Mhz crystal makes this PIC16F877 run at 5MIPS (Million of instructions per second).
Read more: PIC16F877 PWM (2 channel) code and Proteus simulation