This GSM Mobile is used for our Remote Control (for example Gate Control, Temperature Control….). We use the word ‘module’ because, unlike what we did in our remote control projects, this time around the mobile phone is not mounted on a printed board, but rather on a small auxiliary board which is then inserted in a connector specifically created on the main printed board; though this alternative may seem rather complex at first blush, it does have two advantages: the first is that if the GSM module should stop working, and you should not be able to find the same model, you can simply replace it with a different module without having to replace the entire circuit board.
All you need to do is create a small board compatible with your unit, with the pin strips arranged as required by the circuit board. The second advantage is that the module’s printed board is double-faced and can thus host a GSM module on one face and a different one on the other. This provides the option of choosing between two different mobile phones according to one’s needs.
The GSM module
Let us begin by describing the module hosting the mobile phone: it is a printed circuit board measuring about 1.75×1.95 inches, with two pin strips (a 3-pin one and a 16-pin one) used to connect with the circuit board of the remote control device; the first pin strip carries digital power (both positive and negative), in addition to the ignition control line (PWR), while the second strip contains all the communication signals and lines to and from the GSM module, as well as the analogical section of the phones (AGND, contact 11). This pinout remains unchanged regardless of which of the two modules (SIM900 from SIMCom or M10 from Quectel) is in use.
Let’s now take a look at the electrical scheme, which displays the connections for both modules; recall that either GSM1 or GSM2 will be used. The two components have more or less the same command lines, so the relative pins can be connected together with the pin-strip contacts. The main differences between the two modules are found in their reset properties. SIM900 is equipped with a specific reset line, while in the case of M10 it is necessary to turn the power off and short-circuit the VDD_EXT line. In reality, in order to simplify things, the microcontroller’s firmware handles both GSM modules in the same way: in order to reset them, it turns off the main power supply and short-circuits the abovementioned line for just a second.
Read more: GSM Remote Control – GSM Module