Hardware features:
Firmware V4.0 features:
| Connects to your analog scope in X-Y mode using BNC cables or probes (1x, 10x) | |
| Uses the Atmel AVR Atmega328p with 32KB flashmemory | |
| On board 5V power regulator for use with user provided wall adapter (8-15V DC center positive) | |
| Power plug (5.5mm outside diameter) included | |
| On-board Real-Time Clock with 32.768kHz crystal and battery backup: this clock won’t lose time! | |
| Digital to Analog converter with built-in OpAmp (AD7302): no probes required. | |
| On-board true RS-232 level converter for the serial port | |
|
Professionally made dual sided 3″ x 3″ PCB (with solder masks and silkscreen) |
|
| Optional external 5V Power | |
| BNC connectors on PCB: use standard BNC cables | |
| DB9 connector on PCB: use a standard RS-232 cable. | |
| On-Off switch on PCB | |
| Two tactile switches on PCB | |
|
Intensity Control Output, both positive and negative going |
|
| Footprint on PCB for optional USB interface | |
| Header to select power from USB interface | |
| Header for External Clock Signal (GPS 1 Pulse Per Second, Rubidium Oscillator etc.) | |
| Headers provide easy access to TTL level Serial Port | |
| Extensive FAQ document available on this website |
Firmware V4.0 features:
