AT89C4051 to work as a Real time Digital clock Using Atmega

Digital Clock

Its a digial clock which make use of AT89C4051 to work as a Real time clock.

Figure 1 shows the circuit diagram for the digital clock. Port 1 of the controller (AT89C4051) is used as the data lines for the LCD (starting from pin 7- pin14 of LCD). here i am using a 16 x 2 lines LCD display. In the first line, I’ll display “DAY” and “DATE”, in the second line, i am displaying “TIME” with am/pm.

Digital Clock

Port 3 is used for the clock setting and it also provides the necessary control signals for the LCD. As shown in the diagram, switch3 will be used to select the parameter which need to be changed, switch 1 and 2, are used to increase or decrease the selected parameter value.
When the power supply is switched on it will give you the default date and time, but later you can change it to the desired value.
The source code for the project is written in C-language, and compiled using Keil C compiler, you can download the c-code, schematic, and if you don’t have a cross compiler then you can directly burn the HEX file on to your chip,
Figure 2 shows a screenshot of the Digital Clock.

NOTE: If you think that there is a problem in the availability of the chip mentioned in the schematic, then you can also use AT89C51/AT89C52, make sure that you are using the same port for LCD and switches which are there in the C-file or in the schematic.

Read more: AT89C4051 to work as a Real time Digital clock

Leave a Comment

Your email address will not be published. Required fields are marked *