Arduino Sunflower – an Electronic Sundancer

Arduino Sunflower an Electronic Sundancer

Maker is always sensitive to the new and funny things. One day, I watched a video, in which the sunflower moves along with the sun. I had a sudden insight then. Why can’t I make a electronic device inmitating this biomechanism.

Arduino Sunflower an Electronic Sundancer











In the following days, I began to carry out my solar tracker project. I selected the crowtail as the microcontroller board, and picked up the componets and accessories in our warehouse. Then, I assembled these parts together. At last, I tested with the led on my phone. You know what, it worked perfectly.

I was so excited and posted the demo video on the social media. I was surprised that many people liked and shared this video, and some of them even sent me messages saying that they want to make this projects too.

So I redid this projects and make a specific tutorial to let more people make this project. Here we go.

(The code we used is referred to geobruce’s application:, and we make adjustment for pan- tilt use.)

Step 1: PreparationPreparation (2)











The materials we need is listed below.

Cardboard x 2

Foam board x 1

Stick x 1

3 pin crowtail cable x 6

Crowtail- Linear Potentiometer x 2

Crowtail- Light Sensor x 4

Crowtail- Pan- Tilt x 1

Crowduino With ATMega 328 V1.1 x 1

Crowtail- Base Shield for Arduino x 1

Step 2: Make the Head of the DeviceHead of the Device











Firstly, we need to cut the two cardboards as the pictures shows, just for half of cardboard. Then the pieces of cardboards can be assembled as a cross shape. At last, paste the stick with the cross, it will play a role as “head”, and always point to the sun. On the other hand, it can make the device beautiful and stable.

Step 3: Install 4 Light SensorsInstall 4 Light Sensors











Piercing 4 suitable holes to install the 4 sensors, then dig one mid-hole to thread the stick. I numberd these sensors so that we can distinguish their different seat.

Step 4: Connect the Sensors With CablesConnect the Sensors With Cables











Use the glue gun to fix the stick to the foam, and then plug the cables into the sensors

Step 5: Fix the Stick to the Pan-tiltFix the Stick to the Pan tilt











We fix the stick to the pan-tilt. the seat of sensor should keep consistent with the picture. sensor “1“ and sensor ”2” located below site.

The pan-tilt is an assembled device with 9G servos. It can cotrol the vertical and horizontal rotation with 180 degrees.fix the the solar pannel on the foam

At last fix the the solar pannel on the foam. (Notice: the two solar pannels is just for decoration, without power supply function.)

Step 6: Upload the Code

Take out our Crowduino and Crowtail- base shield then stacking them together. Before we start to connect the cables onto base board, we need to upload the program code into crowduino, a micro usb cable is neccessary. Connect the crowduino to our computer, and open the Arduino IDE, click here to download the code and open it with Arduino IDE, then upload.

(Notice that this code is written by geobruce, for more info check his site )

Read more: Arduino Sunflower – an Electronic Sundancer

Leave a Comment

Your email address will not be published. Required fields are marked *