Sometimes you need to do two things at once. For example you might want to blink an LED (or some other time-sensitive function) while reading a button press or other input. In this case, you can’t use
delay(), or you’d stop everything else the program while the LED blinked. The program might miss the button press if it happens during the delay(). This sketch demonstrates how to blink the LED without using
delay(). It keeps track of the last time the Arduino turned the LED on or off. Then, each time through
loop(), it checks if a long enough interval has passed. If it has, it toggles the LED on or off.
To build the circuit, grab an LED and attach its long, positive leg (called the anode) to pin 13. Attach the short, negative leg (called the cathode) to ground. Then plug your Arduino board into your computer, start the Arduino program, and enter the code below.
The code below uses the
millis() function, a command that returns the number of milliseconds since the Arduino board started running its current program, to blink an LED.
Turns on and off a light emitting diode(LED) connected to a digital
pin, without using the delay() function. This means that other code
can run at the same time without being interrupted by the LED code.