Arduino 4-Digit 7-Segment LED Display

4 Digit 7 Segment

7 Segment LED displays are used in many applications as front panel number indicators. The most common applications are calculators, microwave ovens, electronic lab equipment like function generators and frequency counters. 4 Digit 7 Segment

A 7 segment LED display consists of 7 LEDs arranged in such a way that it can display numbers from 0 to 9. The arrangement of LEDs in the display can be either common anode or common cathode.

In this project, a 4 – digit 7 – segment LED display is used to display numbers using Arduino.

Either a compact module containing four 7- segment LED displays can be used or four individual 7 – segment displays can be used by multiplexing them.

Circuit Diagramcircuit Arduino

Components Required

  • Arduino UNO — 1
  • 4 – Digit compact 7 – segment LED display — 1(Or)7 – Segment LED display — 4
  • BC547 — 4
  • 1KΩ — 4
  • 100Ω — 4

Working of 4 – Digit 7 – Segment LED Display

A 7 – Segment LED display, as the name indicates, is an assembly of LED bars, where each bar can be powered individually. Each LED bar is in the form of a hexagon and the overall arrangement will be in the form of ‘8’.

The following figure shows a general representation of 7 – segment LED display with dedicated names to each segment.

Each segment can be powered separately to display digits from 0 to 9. The following figure shows the pattern of digits displayed by a 7 – segment LED display.

As mentioned earlier, in a 7 – segment display, the LEDs can be arranged in common anode or common cathode mode.

The equivalent circuit of a 7 – segment display in common anode and common cathode configuration is shown below.

To determine whether the 7 – segment display is common anode or cathode, a small test circuit can be built. The common terminal of the display is connected to a current limiting resistor.

The resistor is given positive voltage and any of the segments (A to G) is connected to ground. If the segment glows, then it is common anode display.

If the segment doesn’t glow, reverse the polarity of the supply and then it glows. This is a common cathode display.

It is important to determine whether the display is of common anode or common cathode type as the code for Arduino (or any microcontroller) will depend on it.



Read more:  Arduino 4-Digit 7-Segment LED Display

Leave a Comment

Your email address will not be published. Required fields are marked *