The Party Box – Basic using Arduino (Spin Your Disco Ball and More)

In this post, we’ll discuss Party Party – Basque Basque (spin-up-disco ball and more): Party, it’s easy to throw accessories together, you didn’t know you needed to. There are 2 occasions for house parties when there is a desire to make something. Luckily for all of you, this time I kept it so I can show you how it happened:

The Party Box - Basic using Arduino (Spin Your Disco Ball and More)

Tools Required for Spin Disco Ball using Arduino

  • Arduino Power source
  • USB cable
  • Rotational servo
  • Disco Ball
  • Breadboards and jumper cables
  • Firefly string
  • Cable ties

A different type of survey can be performed by rotating the potentiometer continuously. The first time and it worked, but obviously, it will have a constant rotating priority. If you only have a motor, you can use PWM from Aardino to get similar results.
Optionally you can add individually identifiable LED strips (probably WS2812), other LEDs, lasers or whatever you want to add.
One day, make 9000 parties. Consider the plugin and run the latest version. Maybe I’m ready in time for the upcoming Mozambique party.

Assembly should be on weight distribution:

Disco ball has a lot of weight so it will need to be weighed.

So, from the bottom of your battery bank, make the center of your support center almost centralized.

The Ardino battery bank will have a cable attached (or connected to other sources) (if it is made of a suitable material, you may want to place a piece of plastic between the battery bank and the shorts or any strange behavior Can avoid), and bread board. In this version I made, I used Proto Shield and Breadboard so that everything is tied to one side of the cable battery bank. It’s so light that it doesn’t matter much in terms of weight distribution.

To prevent the cervix from slipping down, I attached it to the horizontal cable tie with a wire tie, but you can use a cable tie or something, or some mirror tape, and a cable tie to hold it in place. Can use You can save your Arduino.

If the disco ball is big / heavy, you’ll want to tie the cable horizontally and vertically, although, for me, it wasn’t necessary.

A short USB cable is recommended for best aesthetics.

Connect the firefly string to 5V and ground (make 5v and GND reels on the breadboard if needed) if you do not have a proto shield. And just using a bad board, you’ll want to do the same)

The firefly string is not explicitly needed, but if you can, it beats using a wire or something else to hang your device. Since I have something, I consider it a necessity

Step 2: Additional Components

Downfacing Lighting – I’ve added one (but add as many as you want!) The bright whites face the LEDs down towards the disco ball. Placed a 330 home resistance car between the 3v and a breadboard rail, and then the LED between it and the GND and pointed it out. It would be nice to have a bright ring – make one.

Individually Identifiable LEDs (WS2812B) – I’ve added a strip of Individually Identifiable LEDs that is short in this example (because I’ve used most of them elsewhere) but You can make your belt long enough. Adjust this code accordingly. In the past I have worked several meters with 60 LEDs per meter. Apparently about 5,512 pixels long, the longest part has been blocked.

Laser connected it to 3.3v and GND and also turned it towards the disco ball. He made small trails on the wall after reflecting the disco ball.

Leave a Comment

Your email address will not be published. Required fields are marked *