The E.M.F.Meter Using Arduino

The E.M.F.Meter

The E.M.F.Meter










Hello, fellow Makers!

In this instructable, I will be discussing my newest and most versatile tool for edcuation: the E.M.F. Meter.

This instructable will be covering a lot of steps involving Arduino and Raspberry Pi software. Although resources will be provided, please make sure you have some familiarity with these softwares before tackling this project.

Step 1: A Tool for Hands-On Experiments With Electromagnetism


All to frequently, when students who take physics classes learn about electromagnetism and inductance, they are assigned to memorize formulas from a textbook. As for lab experiences, it would be considered a hands-on science lab if the instructor were to have magnet move through a copper coil and cause an LED to light up.

Being able to truly and organically engrave the laws of electromagnetism into our minds is lost in this style of teaching. My goal with building the E.M.F.Meter was to make a tool that allows students to learn the laws through raw experimentation: to be able to collect enough data to induce the laws for themselves.

With this device, a student can measure the voltage induced in the presence of a moving or changing magnetic field. Its portable size makes it extremely easy to put into various setups to test the laws of magnetism. For instance, one could set the EMF Meter up to measure how a coils voltage changes when a magnet rotates in place. Or, one could alter the coil’s cross section to see how the area and shape affect the voltage over time. The limit is only your imagination.

In this instructable, I will be explaining how to assemble an E.M.F. meter and which resources you should use when setting it up. By the end of this instructable, you will be left with a device that not only measures the voltage and displays it on a TFT screen but also publishes the data to a single browser which can display an entire class’s data.

Step 2: The ADS1115 Featherwing: a RecapFeatherwing











In my previous instructables, I described my first featherwing that requires surface-mounted soldering to make.

If you have not read this instructable yet, see here.

For a brief recap for those who have seen this instructable, the ADS1115 featherwing is a custom made device that is meant to:

-Measure voltages through two channels (one voltage source per channel)

-Amplify the measured voltage (optional)

-Fit the form factor of the Adafruit feather/featherwing family to encourage interchangeability and simplicity

Since the E.M.F. Meter’s job is to measure the voltage produced from changing magnetic fields, this featherwing is crucial to have. Make sure that you have a properly built ADS1115 featherwing before starting.

Step 3: Additional Components: Hardware

Hardware 1 (2)















The hardware you will need are the following:

Adafruit HUZZAH Feather: This feather is able to wirelessly send data through a protocol called MQTT. This itself does not publish data onto a browser but it does send it to a host sever (the raspberry pi) which then publishes it to a specified wifi.

Adafruit TFT Featherwing: This wing is what will be displaying the voltage-time graph on the E.M.F. Meter itself.

Raspbery pi 3B: This board is a computer that will be acting as the MQTT Host that recieves the HUZZAH feather’s data and publishes it to the wifi.

PiTop (Optional, but strongly suggested): This is the physical interface that the raspbery pi will be placed in to make it easier to use (for finding IP addresses in particular).

Step 4: Additional Components: SoftwareAdditional Components Software











Arduino: Make sure you have the newest Arduino available. It is completely free.

Read more: The E.M.F.Meter

Leave a Comment

Your email address will not be published. Required fields are marked *