Step-by-step guide for making a very simple temperature and humidity meter with 7-segment LED displays using arduino

humidity meter with 7 segment

In this blog post, I am providing you step by step instructions to build a very simple temperature and relative humidity meter for indoor use. All you need to build this project are an Arduino Uno or compatible board, a DHT11 sensor, and a MAX7219 based 8-digit serial 7-segment LED display. The temperature is displayed in degree Celsius and relative humidity in percentage.humidity meter with 7 segment

Things required to build this project

Arduino Uno board

I am using Crowduino Uno SD board, which is manufactured by Elecrow and is fully compatible with Arduino Uno board. Crowduino has the following additional features that the standard Arduino Uno board doesn’t have.

1 Reset button is placed on the left side edge, and thus more convenient to access.

2 Improved power supply circuit with selectable 3.3V and 5.0V for operation.

3 Uses the mini USB connector to avoid the potential risk of connecting to the shield plugged in.

4 Micro SD card slot on board, which makes this board useful for data logging applications.humidity meter with 7 segment

DHT11 sensor

DHT11 is an ultra low cost digital sensor for measuring temperature and relative humidity. It operates from 3.0-5.0V and provides calibrated digital outputs for temperature (in degree Celsius) and humidity through a single wire serial interface. It can measure humidity ranging from 20-80% with 5% accuracy, and temperature ranging from 0-50 degree Celsius with 2% accuracy. When it is active, the maximum current consumption is 2.5mA. The sensor has 4 pins with 0.1” spacing as shown below.

MAX7219-based seven segment display

The next thing required to do this project is two rows of 4-digit seven segment LED displays for displaying temperature and humidity simultaneously. This project uses SPI7SEGDISP8.56-2R display module, which is MAX7219 driven and allows you to control all 8 digits through a 3-wire serial interface. The display brightness can also be adjusted through software commands. In addition, library routines are available for interfacing the SPI7SEGDISP8.56-2R module to Arduino. This project, in particular, uses the LedControl library.

Jumper cables

We will also need a few male-to-female type jumper wires to connect the parts together.

Power supply

You can use an USB cable connected to PC or a 9V DC wall adapter to power this project.

Project setup

In this project, we insert the DHT11 sensor directly into the right female headers of the Arduino Uno board such that the pin 4 (GND) of DHT11 goes in to the GND pin (second pin from top right) of the Arduino header. With this arrangement, the pins 1 (VCC), 2 (Data), and 3 (NC) of DHT11 will be connected to Arduino digital I/O pins 11, 12, and 13, respectively. Since DHT11 requires only 2.5mA current at most during operation, it will be powered directly through Arduino pin 11 by setting it to 1. The Arduino pin 12 is used to read the sensor output.

Leave a Comment

Your email address will not be published. Required fields are marked *