How to interface keypad with PIC12F675

interface keypad

This post provides a simple method to interface any keypad (e-g 4×4 or 4×3 etc) with PIC12F675 microcontroller. The code for PIC12F675 is written in C language using MPLAB with HI-TECH C compiler. You can download this code from the ‘Downloads‘ section at the bottom of this page.

interface keypad

In this post, it is assumed that you know,

  • How to use ADC of PIC12F675 microcontroller. If you don’t then please read this page.
  • How to interface LCD with PIC12F675 microcontroller. If you don’t then please read this page.

The circuit required to interface keypad with PIC12F675 is shown below.

The result of simulating the code in Proteus is shown above in the figure. This code is written in such a way that when you press any key from the keypad, then the value of that key is displayed on the LCD. For example, in the above figure LCD screen is displaying ‘1’, because this picture was taken after pressing ‘1’ from the keypad.

In the above circuit, PIC12F675 is running on it’s internal 4MHz oscillator. GP0, GP1 and GP2 pins are used to interface LCD through 4094 IC as explained in the “PIC12F675 LCD Interfacing Code + Proteus Simulation” post. LCD is used here just to show the pressed key value. Usually 8 pins are used to interface 4×4 keypad with any microcontroller. 4 pins are used to attach columns and 4 pins are used to attach rows and scanning algorithm code is used to check for any pressed key.

But PIC12F675 doesn’t have 8 pins. By using some diodes we can generate different voltage on each pressed key on a single wire (as shown above in the circuit). And then by using built-in ADC of PIC12F675 we can read this voltage value to determine pressed key easily. In this way by using only one pin of PIC12F675 we can successfully interface keypad with it. To interface keypad, only GP4(AN3) pin is being used in the circuit shown above.

In the above circuit, rows of the keypad have 1N4007 diode attached with them. If you don’t have 1N4007 diode, then any simple 0.7 volt[1] diode can be used here. RowA has 3 diodes, RowB has 2 diodes, RowC has one diode and RowD has no diode attached with it. These diodes are pulled-up from one side by a 470 ohm resistor. Column1 wire of keypad is attached with the ground. Column2 is attached with a schottky diode[2]. Column3 is attached with a 2.7v zener diode. Column4 is attached with a 3.0v zener diode. Using this circuit you can easily interface keypad with PIC12F675 microcontroller.

interface keypad schematic

Leave a Comment

Your email address will not be published. Required fields are marked *