GoPRO Shutter Using Arduino

Arduino GoPRO libraries

This tutorial relies on the use of the Arduino GoPRO libray that can be installed using the Arduino Library Manager.

This library allows the user to fully communicate with a GoPRO camera, but we will use only two very basic functions:

• Turn ON and OFF the camera;
• Start or stop the capture;

How it Works

The libraries relies on the fact that a connection between the camera (in AP mode) and the board exist.

The library has so the method GoPRO.begin(ssid, pass) to try a connection. This function in fact returns true if the connection is established falseotherwise.

The sketch interacts with three buttons:

• Connect/Disconnect (attached to A1);
• Turn ON/OFF the camera (attached to A2);
• Start/Stop Capture (attached to A3);

Pressing the buttons reflects to the status of the three LEDs in such a way:

• Blue LED: when the connect button is pressed, the board tries to establish a connection with the camera. If the connection is successful, the LED will be turned ON. If pressed another time the connection will be stopped and the LED is turned OFF;
• Green LED:when the turn ON/OFF button is pressed, the board sends the turnOn() command if the LED is OFF the turnOff() command otherwise;
• Red LED:when the Start/Stop Capture button is pressed, the board sends the startCapture() command if the LED is OFF the stopCapture()command otherwise;