Tiny Board has been designed around LV8772 IC from On-Semi. This driver is capable of micro-step drive and supports 4W 1-2 phase excitation. It has Low on Resistance with motor current selectable in four steps. The board is equipped with unusual condition warning LED and input Pulse Monitor LED. It is most suitable for the drive of a stepping motor for OA, amusements, hobby CNC, 3D printers, automatic machines, linear guides, motion control systems, XY gantry, Camera focus and zoom controller, Mini camera Pan Tilt Head.


  • Power Supply input 9V to 30V (Max 32V)
  • Output Current 2.5Amps
  • Very low noise and smooth operations
  • Very low noise in slow speed
  • Low on resistance (Total of upper and lower: 0.55ohms)
  • Micro-Step mode can be set to Full-Step, 1/2 Step,1/4,1/16 Steps
  • Motor Current selectable in four steps
  • Output short circuit protection circuit incorporated (IC)
  • Built in thermal shutdown circuit
  • No Control power supply required
  • Input Signals 1. Step (Clock) 2. Direction 3. Enable 4. Reset
  • This Drive default set to enable and reset
  • Current Setting via onboard Preset (Potentiometer)
  • Attenuation ATT1 and ATT2 by Jumpers
  • Two Jumpers for Micro-Step settings
  • On-Board Fault Warning LED
  • On-Board Pulse Input indication LED



  • Slot Machine
  • Vending Machine
  • Cash Machine
  • PPC (Plain Paper Copier)
  • LBP (Laser Beam Printer)
  • Scanner
  • CNC
  • 3D Printers
  • Textile
  • Camera Pan Tilt Head
  • Camera Focus and Zoom Controller

Chip Enable Functions (Default this pin set to high for normal operation)

  • ST Pin High Operation Mode, Low Disable the drive
  • This IC is switched between standby and operating mode by setting the ST pin, In standby mode, the IC is set to power-save mode and all logic is reset. In addition, the internal regulator circuit and charge pump circuit do not operate in standby mode.

Position detection monitoring function (LED MO, D2)

  • When the excitation position is in the initial position, the Monitor output LED MO D2 placed in the ON State

Setting constant-current control reference current (PR1 Potentiometer)

  • Potentiometer PR1 is to set the Current

RESET Function (Default this pin set to normal operation using pull down resistor R10)

  • Reset Pin Low = Normal Operation, Reset Pin High = Reset State
  • When The RST pin is set to High, the excitation position of the output is forcibly set to the initial state, and the Moni -D2 LED is in ON state, When RST is set to low , the excitation position is advanced by the next STEP input

Output Short Circuit

Output Short-Circuit protection type of IC is latch type to turn off when the output current exceeds the detection current and the state is maintained.  The output short-circuit protection circuit is activated in and event of short-circuit in the output pin. When the short-circuit state continues for a period of time set by the internal timer (approximately 4uS), the output in which short-circuit was first detected are switched to the standby mode, And if the short-circuit state is still detected, all the outputs of the channel are switched to the standby mode, and the state is held, this state is released by setting ST to low.


Leave a Comment

Your email address will not be published. Required fields are marked *